From: Jason Sinclair (sinclairj@powertel.com.au)
Date: Sun Sep 22 2002 - 23:34:44 GMT-3
This can be manipulated by adjusting the hello timer.
Jason Sinclair CCIE #9100
Manager, Network Control Centre
POWERTEL
55 Clarence Street,
SYDNEY NSW 2000
AUSTRALIA
office: + 61 2 8264 3820
mobile: + 61 416 105 858
email: sinclairj@powertel.com.au
-----Original Message-----
From: Young Bae [mailto:ybae@cisco.com]
Sent: Monday, 23 September 2002 11:59
To: ccielab@groupstudy.com
Subject: Changing the OSPF Dead-Interval
Hello,
I hate asking this type of question to such an advanced audience like this
one, but can someone tell me how one can change the OSPF Dead-Interval
timer without using the "ip ospf dead-interval" command. For example, if
I were to change the interval to twice its default value (for both p-to-p
and NBMA type interface), what would I do?
Thanks in advance,
**********************************************************************
PowerTel Limited, winners of
Broadband Wholesale Carrier of the year, CommsWorld Telecomms Awards 2001
Best Emerging Telco, Australian Telecom Awards 2001
**********************************************************************
This email (including all attachments) is intended solely for the named
addressee. It is confidential and may contain commercially sensitive
information. If you receive it in error, please let us know by reply email,
delete it from your system and destroy any copies.
This email is also subject to copyright. No part of it should be reproduced,
adapted or transmitted without the prior written consent of the copyright owner.
Emails may be interfered with, may contain computer viruses or other defects
and may not be successfully replicated on other systems. We give no
warranties in relation to these matters. If you have any doubts about
the authenticity of an email purportedly sent by us, please contact us
immediately.
**********************************************************************
This archive was generated by hypermail 2.1.4 : Mon Oct 07 2002 - 07:44:00 GMT-3