From: McClure, Allen (Allen.McClure@Tricon-Yum.Com)
Date: Mon Oct 07 2002 - 13:13:17 GMT-3
I'm not very good at DLSW or SNA, but here's two cents (if that).
Keep in mind that DLSW advertises what it CANNOT reach as well. I had
to advertise that I could not reach NetBIOS SAPs as part of a lab I did.
Basically like...
Dlsw icannotreach saps F0 F1
I didn't realize this and used an access-list, which didn't really meet
the requirement.. Which was that the router shouldn't receive traffic
for NetBIOS, not that it should receive it and then drop it (which is
what my solution did).
Just a thought, I'm not sure if this applies in your requirement.
Allen McClure
MCSE, CCNP, CCDP
YUM! Brands, Inc.
Sr. Network Analyst
NEW E-Mail - mailto:allen.mcclure@yum.com
972-338-7494
-----Original Message-----
From: beda jain [mailto:bpjain@cisco.com]
Sent: Friday, October 04, 2002 10:34 AM
To: George Bekmezian; 'chenyan'; 'ccielab'
Subject: permit only sna between dlsw peer
Hi,
then i should do this
dlsw icanreach sap 0 4 8 c
or
dlsw icanreach sap 0 1 4 5 8 9 c d
Thanks,
Beda
This communication is confidential and may be legally privileged. If you are not the intended recipient, (i) please do not read or disclose to others, (ii) please notify the sender by reply mail, and (iii) please delete this communication from your system. Failure to follow this process may be unlawful. Thank you for your cooperation.
This archive was generated by hypermail 2.1.4 : Tue Nov 05 2002 - 08:35:41 GMT-3