From: Cary Anderson (cary@cisco.com)
Date: Fri Nov 15 2002 - 11:29:12 GMT-3
Int range fa0/21 - 24
Channel-group 1 mode on
Int port-channel 1
No switchport
Ip address x.x.x.x mask
Off the top of my head, I think the above would work.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
liqunhui@pub.xaonline.com
Sent: Thursday, November 14, 2002 10:18 PM
To: ccielab@groupstudy.com
Subject: Re: 3550 layer 3 etherchannel
you should create interface port-channel first!!
> -----Original Message-----
> 7"<~HK: "Weidong Xiao" <Weidong.Xiao@vi.net>
> HUFZ: Wed, 13 Nov 2002 19:53:02 -0000
> JU<~HK: <ccielab@groupstudy.com>
> VwLb: 3550 layer 3 etherchannel
> Hi group,
>
> I was running EMI on a 3550 and 'ip routing' enabled, but couldn't set
> up a layer 3 etherchannel.
> Can somebody tell me what I missed?
>
> Thanks in advance,
>
> Weidong
>
> --------------------------------
> interface FastEthernet0/1
> description LINK-TO-RSW1
> no ip address
> duplex full
> speed 100
> channel-group 1 mode desirable non-silent
> !
> interface FastEthernet0/2
> description LINK-TO-RSW1
> no ip address
> duplex full
> speed 100
> channel-group 1 mode desirable non-silent
>
> and then:
>
> SW3(config)#interface Port-channel1
> SW3(config-if)#no sw
> SW3(config-if)#no switchport
> Command rejected: Not a convertable port. <-------WHY?
> SW3(config-if)#ip address 2.2.2.2 255.0.0.0
>
> % IP addresses may not be configured on L2 links.
----------------------------------------------
;6S-J9SC XAONLINE 5gWSSJ<~O5M3 http://www.xaonline.com
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:23:01 GMT-3