From: Kevin Tang (Kevin.Tang@telecom.co.nz)
Date: Sun Nov 17 2002 - 05:09:44 GMT-3
Also you need add local policy routing in R3 and R4. Because you are using OSPF multi-access network, (not point-to-point or point-to-multipoint network) and the frame-switch network is not full-mesh network. R3 and R4 talk to each other have to via R2.
-----Original Message-----
From: Jennifer Bellucci [mailto:Jennifer_bellucci@hotmail.com]
Sent: Sun 17/11/2002 11:22 a.m.
To: eric; Nate Kleven; CCIElab@groupstudy.com
Cc:
Subject: Re: OSPF On NBMA with a twist
insert neighbour command under ospf and don't forget to turn of ip split
where needed
----- Original Message -----
From: "eric" <namaste@pacbell.net>
To: "Nate Kleven" <cciemail@intellinet.ws>; <CCIElab@groupstudy.com>
Sent: Saturday, November 16, 2002 9:31 PM
Subject: RE: OSPF On NBMA with a twist
> You have 2 issues to address here take a look at the timers on the diff.
> interfaces and then address any DR issues that might come up.
>
> ~e
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> Nate Kleven
> Sent: Saturday, November 16, 2002 12:33 PM
> To: 'CCIElab@groupstudy.com'
> Subject: OSPF On NBMA with a twist
>
>
> R2
> / \
> / \
> / \
> R4 R3
>
> Hub and Spoke Topology
> R2 Has a PVC to R4 and R3
>
> - R2/R3/R4 Share the 10.10.10.0/27 Network
> - R4 Must be configured using a Physical Interface
> - R3 & R2 Must be configured using Sub-interfaces
> - R2's Serial Subinterface must be configured as a multipoint interface,
not
> a Non-broadcast.
> - You may not use the "IP OSPF NETWORK" command on R3
>
> I have not been able to get this working and meet all th requirements.
> Anyone out there seen this before?
>
>
> Thanks in advance.
>
>
> Nate
------------------------------------------------------------------------------
"This communication, including any attachments, is confidential.
If you are not the intended recipient, you should not read
it - please contact me immediately, destroy it, and do not
copy or use any part of this communication or disclose
anything about it. Thank you."
------------------------------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Tue Dec 03 2002 - 07:23:02 GMT-3