From: Brian Sims (BSims_1@msn.com)
Date: Mon Apr 07 2003 - 22:44:39 GMT-3
Hi,
I have the daily duties of implementing voice networks of about 40 phones per
install. I am using a VG200 for the voice gateway. I have enabled caller-id
on my voice ports and the local telephone carrier is sending caller-id across
their analog line but I'm still not getting any caller information from an
outside caller. Anybody have any ideas? I have attached a copy of the VG200
configs to this email. Thanks in advance.
Brian
version 12.1
no service single-slot-reload-enable
no service pad
service timestamps debug datetime msec localtime
service timestamps log datetime msec localtime
!
hostname Flowers-ES-vg200
!
logging rate-limit console 10 except errors
no logging console
enable secret 5 $1$72BH$38oMBaKLMFhiNS2l6PEbW/
!
ip subnet-zero
no ip finger
!
no mgcp timer receive-rtcp
call rsvp-sync
!
!
interface FastEthernet0/0
ip address 10.195.0.10 255.255.0.0
no ip route-cache
no ip mroute-cache
duplex auto
speed auto
!
ip default-gateway 10.195.0.1
ip classless
ip route 0.0.0.0 0.0.0.0 10.195.0.1
no ip http server
!
voice-port 1/0/0
!
voice-port 1/0/1
!
voice-port 1/1/0
connection plar 25002
description 260-1015
caller-id enable
!
voice-port 1/1/1
connection plar 25002
description 260-1047
caller-id enable
!
dial-peer voice 1 pots
destination-pattern 9T
port 1/1/0
!
dial-peer voice 2 pots
destination-pattern 9T
port 1/1/1
!
dial-peer voice 100 voip
destination-pattern 250..
session target ipv4:10.5.0.11
dtmf-relay h245-alphanumeric
codec g711ulaw
no vad
!
line con 0
!
line aux 0
line vty 0 4
login
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:35:48 GMT-3