From: Tom Young (gitsyoung@yahoo.co.jp)
Date: Tue Apr 29 2003 - 09:00:07 GMT-3
Thanks for your reply, you means if I use the f/r , the
default type for serial port is multipoint ? But could I
set the for point-to-point ?
THanks again
--- Carlos <cchorao@xtra.co.nz> $B$+$i$N%a%C%;!<%8!'(B
> Tom ,
>
> I assume you are referring to frame-relay for
> encapsulation ?
> Config in the main interface operates as mulitpoint
> by default.
>
>
>
>
>
>
>
>
>
>
>
> Carlos Chorao (CCIE 11351 R&S)
>
> Senior Technical Consultant
> Telecom New Zealand
> Advanced Solutions Group -Network Design and
> Security
>
> Network Security and Design
> ----- Original Message -----
> From: "Tom Young" <gitsyoung@yahoo.co.jp>
> To: <ccielab@groupstudy.com>
> Sent: Tuesday, April 29, 2003 8:57 PM
> Subject: the multipoint main interface
>
>
> > Hi, group
> >
> > If I use the subinterface of serial port to
> connecting
> > several remote office, I could set the multipoint
> for it,
> > but if I use the main interface, not the
> subinterface ,
> > Can I still set it for multipoint? I couldn't
> found the
> > command.
> >
> > Thanks alot
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Yahoo! BB is Broadband by Yahoo!
> http://bb.yahoo.co.jp/
> >
>
This archive was generated by hypermail 2.1.4 : Thu May 01 2003 - 13:36:09 GMT-3