From: Sage Vadi (sagevadi@yahoo.co.uk)
Date: Sun Jun 08 2003 - 05:24:21 GMT-3
I would assume here that you are referring to the OSPF
Demand Circuit as per RFC1793. You can use the, "no
peer neighbor-route" to remove /32 host routes from
the routing table.
Fromt the command ref:
"Disabling or Reenabling Peer Neighbor Routes
The Cisco IOS software automatically creates neighbor
routes by default; that is, it automatically sets up a
route to the peer address on a point-to-point
interface when the PPP IPCP negotiation is completed."
--- Yunjie Chen <ychen@houston.sns.slb.com> wrote: >
Hi,
> I am facing a lab scenerio asking for
> Configure the ISDN circuit such that the /32 bit
> host routes are not created when the link is
> established..
>
> what is the command to do so?
>
> thanks a lot..
>
> Yunjie
This archive was generated by hypermail 2.1.4 : Fri Jul 04 2003 - 11:10:54 GMT-3