From: Muhamamd Durrani (dan_schaw@yahoo.com)
Date: Wed Sep 10 2003 - 19:12:21 GMT-3
minimum command as possible .
So I would say only on HUB is sufficient
Regards
--- navaid@rogers.com wrote:
> As you can see in example from Doc. CD, neighbor
> command is only used on hub and no neighbor command
> on other router. I am having problem with adj. when
> command is only on Hub router. what is correct way
> to configure point to multipoint nonbroadcast, the
> way that works or the way that is documented in CD ?
>
>
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fipr_c/ipcprt2/1cfospf.htm#1001760
>
> OSPF Point-to-Multipoint, Nonbroadcast Example
> The following example illustrates a
> point-to-multipoint network with nonbroadcast:
>
> interface Serial0
> ip address 10.0.1.1 255.255.255.0
> ip ospf network point-to-multipoint non-broadcast
> encapsulation frame-relay
> no keepalive
> frame-relay local-dlci 200
> frame-relay map ip 10.0.1.3 202
> frame-relay map ip 10.0.1.4 203
> frame-relay map ip 10.0.1.5 204
> no shut
> !
> router ospf 1
> network 10.0.1.0 0.0.0.255 area 0
> neighbor 10.0.1.3 cost 5
> neighbor 10.0.1.4 cost 10
> neighbor 10.0.1.5 cost 15
> The following example is the configuration for the
> router on the other side:
>
> interface Serial9/2
> ip address 10.0.1.3 255.255.255.0
> encapsulation frame-relay
> ip ospf network point-to-multipoint non-broadcast
> no ip mroute-cache
> no keepalive
> no fair-queue
> frame-relay local-dlci 301
> frame-relay map ip 10.0.1.1 300
> no shut
> !
> router ospf 1
> network 10.0.1.0 0.0.0.255 area 0
>
> 1
>
>
>
This archive was generated by hypermail 2.1.4 : Wed Oct 01 2003 - 07:24:26 GMT-3