From: Michael Whisenant (mwhisen@hiwaay.net)
Date: Sun Dec 07 2003 - 16:55:46 GMT-3
Ok I am stuck...
I am told "do not use any DLCI's not specified in this section" and am told
that the verification is the output of the show frame-relay pvc command.
The expected output on all devices are only those that I have static mappings.
I have all routers with all interfaces administratively down. No
configurations at all on the serials. I then do show frame-relay pvc and
get nothing. I completed configure the interface (either physical or
logical multipoint subinterface. I check the output of show frame-relay pvc
and only have the expected DLCI's. I then no shut the interface and almost
immediately on the physical interfaces the other DLCI's are know and bound
to the physical interface. I verify that I have no arp frame-relay and no
frame-relay inverse-arp on all interfaces and it is still there.
I have read somewhere and hear rumors that this will result in a loss of
points for the section. I have reread Doyle, Solie, and Cisco.com and have
the commands that they suggest. I have also copy run start and reloaded the
device as well. NO LUCK.... Help please...
This archive was generated by hypermail 2.1.4 : Sat Jan 03 2004 - 08:25:37 GMT-3