From: Vazman@aol.com
Date: Tue Dec 16 2003 - 23:45:53 GMT-3
Hi guys,
I have a franken pix that I am using for my lab. I upgraded the OS from 5.2 to 6.22. After I rebooted the pix, it stopped recognizing my NIC cards. All NIC's are brand new Intel Pro100 cards and they worked fine with 5.2. Any suggestions? Do I need to use any specific cards with 6.22. See error below:
***********************************************
Cisco PIX Firewall Version 6.2(2)
Licensed Features:
Failover: Enabled
VPN-DES: Enabled
VPN-3DES: Disabled
Maximum Interfaces: 6
Cut-through Proxy: Enabled
Guards: Enabled
URL-filtering: Enabled
Inside Hosts: Unlimited
Throughput: Unlimited
IKE peers: Unlimited
Not enough supported network interface cards installed.
PIX requires at least 2 supported interface cards,
but only 0 supported interfaces were found.
Rebooting....
Cisco Secure PIX Firewall BIOS (3.6)
Booting Floppy
Flash=i28F640J5 @ 0x300
Reading 1536512 bytes of image from flash.
################################################################################
##
96MB RAM
Ignoring PCI card in slot:0 (vendor:0x8086 deviceid:0x1229 revisionid:0xc)
Ignoring PCI card in slot:1 (vendor:0x8086 deviceid:0x1229 revisionid:0xc)
Ignoring PCI card in slot:2 (vendor:0x8086 deviceid:0x1229 revisionid:0xc)
Ignoring PCI card in slot:3 (vendor:0x8086 deviceid:0x1229 revisionid:0xc)
Flash=i28F640J5 @ 0x300
BIOS Flash=AT29C257 @ 0xfffd8000
This archive was generated by hypermail 2.1.4 : Sat Jan 03 2004 - 08:25:42 GMT-3