From: Mark Rushby (mark@tisolutions.biz)
Date: Tue Feb 24 2004 - 17:40:20 GMT-3
Hi All
The command ip precedence does not appear as an option under dial peer on my 2600 running ver 12.3.
Yet when i enter the command "ip precedence 5" it is accepted, but when i check the config it appears as "ip qos dscp cs5 media"
Any ideas whats happening?
tia
Mark
config:
voice-port 1/0/0
!
voice-port 1/0/1
!
!
!
dial-peer voice 1 pots
destination-pattern 4567
port 1/0/0
!
dial-peer voice 2 voip
destination-pattern 7890
session target ipv4:170.1.7.7
ip qos dscp cs5 media
R4#sh vers
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-J1S3-M), Version 12.3(1), RELEASE SOFTWARE (fc3)
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Thu 15-May-03 13:12 by dchih
Image text-base: 0x80008098, data-base: 0x819BC684
ROM: System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
R4 uptime is 3 hours, 0 minutes
System returned to ROM by power-on
System image file is "flash:c2600-j1s3-mz.123-1.bin"
cisco 2611 (MPC860) processor (revision 0x203) with 59392K/6144K bytes of memory
.
Processor board ID JAD041506PA (2001284474)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
TN3270 Emulation software.
Basic Rate ISDN software, Version 1.1.
2 Ethernet/IEEE 802.3 interface(s)
1 Serial network interface(s)
1 ISDN Basic Rate interface(s)
2 Voice FXS interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
R4#
This archive was generated by hypermail 2.1.4 : Fri Mar 05 2004 - 07:13:56 GMT-3