From: Church, Chuck (cchurch@wamnetgov.com)
Date: Fri Mar 19 2004 - 00:36:45 GMT-3
1700s will run CEF with later code. Check the software navigator. I
know 12.2T does it, might need Plus though. I would get off that
ancient 12.0 code anyway.
Chuck Church
CCIE #8776, MCNE, MCSE
Wam!Net Government Services
13665 Dulles Technology Dr. Ste 250
Herndon, VA 20171
Office: 703-480-2569
Cell: 703-819-3495
cchurch@wamnetgov.com
PGP key:
http://pgp.mit.edu:11371/pks/lookup?op=index&search=cchurch%40wamnetgov.
com
> -----Original Message-----
> From: Sergio Jimenez Arguedas [mailto:sejimenez@its.co.cr]
> Sent: Thursday, March 18, 2004 3:22 PM
> To: ccielab@groupstudy.com
> Subject: Fw: Load Balancing Scenario!!!
>
>
> Can somebody help me, please?
>
>
> Rgds,
>
>
> Sergio
>
>
> ----- Original Message -----
> From: Sergio Jimenez Arguedas
> To: ccielab@groupstudy.com
> Sent: Thursday, March 18, 2004 10:40 AM
> Subject: Load Balancing Scenario!!!
>
>
> Hi all,
>
>
> Can somebody help with the following situation?
>
>
>
>
>
> _s0____________EIGRP__________s0_
> NetA ----EIGRP------R1
> R2
> --s1----------
> ----EIGRP--------------s1--
>
>
> R2 is a 1700 router with an IOS 12.0(7)
>
> R2 has two routes to NetA with the same metric, so EIGRP
> makes load balancing.
>
> R2 has fastswitching and I want to make loadbalancing
> per-packet. I CAN4T use CEF because the router doesn4t
> support it, also I don4t want to use Proccess Switching in
> order to avoid problems with the CPU.
>
> How about.......EIGRP Feature: traffic-share min across-interfaces?
>
> It says:
> When the traffic-share min command is used with the
> across-interfaces keyword, an attempt is made
>
> to use as many different interfaces as possible to forward
> traffic to the same destination. When the
>
> maximum path limit has been reached and a new path is
> installed, the router compares the installed paths.
>
> For example, if path X references the same interface as path
> Y and the new path uses a different interface,
>
> path X is removed and the new path is installed.
>
> To configure traffic that is distributed among multiple
> routes of unequal cost for equal cost paths across
>
> multiple interfaces, use the following command in router
> configuration mode: R2(Config-Router)#traffic-share min
> across-interfaces
>
>
>
>
>
> I really don4t understand if it is per-packet with that
> feature of EIGRP, because R2 has FASTSWITCHING!!!
>
>
>
>
>
> Thanks,
>
>
>
>
>
> Sergio Jiminez A.
>
> ______________________________________________________________
> _________
> Please help support GroupStudy by purchasing your study
> materials from: http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Thu Apr 01 2004 - 08:15:35 GMT-3