From: Richard Gallagher (rgallagh@cisco.com)
Date: Fri Apr 09 2004 - 07:54:05 GMT-3
Unfortunately this is not currently supported, it should be in the
future but not sure when. A feature-request is open for this. So you'll
just have to wait a little longer :(
Rich
On Fri, 2004-04-09 at 12:48, Kristof Ulrix wrote:
> Hi group,
>
> I would like to use policy-routing on vrf-interfaces,
> but I get the following:
>
> R1#conf t
> Enter configuration commands, one per line. End with CNTL/Z.
> R1(config)#int fa3/0
> R1(config-if)#ip policy route-map Test
> R1(config-if)#ip vrf forwarding Mgmt
> % Remove Policy-Based Routing from interface FastEthernet3/0 first
> R1(config-if)#no ip policy route-map Test
> R1(config-if)#ip vrf forwarding Mgmt
> R1(config-if)#
>
> Is there another way to policy-route packets in a VRF?
>
> Thanks in advance,
>
> Kristof Ulrix.
>
> _______________________________________________________________________
> Please help support GroupStudy by purchasing your study materials from:
> http://shop.groupstudy.com
>
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon May 03 2004 - 19:48:44 GMT-3