Passive-interface loopback0

From: Peter Ding (pding@cisco.com)
Date: Thu Jul 08 2004 - 01:42:20 GMT-3

• Next message: Tom Rogers: "Re: Limitations of 3550emi"
• Previous message: Larry Roberts: "RE: Eigrp unequal load balancing problem"
• Next in thread: Neo Shi: "Re: Passive-interface loopback0"
• Maybe reply: Neo Shi: "Re: Passive-interface loopback0"
• Maybe reply: ccie2be: "Re: Passive-interface loopback0"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Assume I have the lab setup as the following:

R1 -(eigrp)- R2 -(ospf)- R3

loopback0 on R2 is advertised by eigrp. R2 and R3 are connected with Frame
Relay and ISDN.

Is it must to configure "passive-interface loopback0" on R2 in order not to
sent multicast traffic over ISDN link?

router eigrp 90
  passive-interface loopback0

Thanks,

PD

• Next message: Tom Rogers: "Re: Limitations of 3550emi"
• Previous message: Larry Roberts: "RE: Eigrp unequal load balancing problem"
• Next in thread: Neo Shi: "Re: Passive-interface loopback0"
• Maybe reply: Neo Shi: "Re: Passive-interface loopback0"
• Maybe reply: ccie2be: "Re: Passive-interface loopback0"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Aug 01 2004 - 10:11:49 GMT-3