From: kasturi cisco (kasturi_cisco@hotmail.com)
Date: Wed Aug 18 2004 - 11:49:20 GMT-3
Hi,
Yes there a couple of things to watch out for when doing this -
One dont over do any cmd and give excess cmds as it wont fetch u
anything.Also ensure ur doing something for all ports by default wont
hurt u later (without ur knowledge).
Two, ensure u do what is required by the Q.Re read the Q.If for example
the Q says in an example - configure the port to be a access port at all
times ...then such a cmd will help. this will ensure that the port is a
Access port and wont dynamically switch to a trunk port.
Good Luck,
Kasturi.
------------------------------------------------------------------------
Sell what you dont Need. Click Here!
This archive was generated by hypermail 2.1.4 : Fri Sep 03 2004 - 07:02:45 GMT-3