From: Jonathan R. Charles (jrcdehc@ameritech.net)
Date: Tue Sep 21 2004 - 02:07:37 GMT-3
Sorry, I wasn't clear, I was asking about setting up ILMI so that I could
use the switch to tell the routers what their NSAP prefix was.
I found the following:
atm ilmi default-access permit all
and on the interface,
atm ilmi-keepalive
is that all I need?
Jonathan
-----Original Message-----
From: marc russell [mailto:mrussell@ccbootcamp.com]
Sent: Monday, September 20, 2004 23:06
To: 'Jonathan R. Charles'; ccielab@groupstudy.com
Subject: RE: Sample LS1010 config [bcc][faked-from]
Only one command per PVC is required. See below. The one command "atm
pvc 1 66 interface ATM0/0/0 1 55" will create a PVC between int
ATM/0/0/0 and int ATM0/0/1.
interface ATM0/0/0
!
interface ATM0/0/1
atm pvc 1 66 interface ATM0/0/0 1 55
Marc Russell
Network Learning, Inc.
www.ccbootcamp.com (Cisco Training)
www.optsys.net (Cisco hardware)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Jonathan R. Charles
Sent: Monday, September 20, 2004 11:26 PM
To: ccielab@groupstudy.com
Subject: Sample LS1010 config [bcc][faked-from]
Importance: Low
I got assigned a rack of equipment, and it looks like no pvcs are built
on
the LS1010, does anyone have a good sample config on how you do the
equivalent of the frame-relay route commands for ATM?
Thanx
Jonathan
This archive was generated by hypermail 2.1.4 : Fri Oct 01 2004 - 15:00:46 GMT-3