From: venkat garigipati (garigipati@yahoo.com)
Date: Fri Sep 24 2004 - 22:07:12 GMT-3
Right, R5 is not allowed to call R4, but only R4 can make calls to R5. the reason i used dialer idle-timeout 0 is that R5 should never disconnect
Richard Dumoulin <Richard.Dumoulin@vanco.fr> wrote:
I interpret "...R5 is not allowed to call R4..." as "do not configure an isdn number under the dialer map command". As this is what you have done
I don't see anything wrong in putting the dialer-group.
I have noticed in Cisco papers that they always put it in the bri/dialer interfaces. Then if they don't want to define interesting traffic they just configure dialer-list protocol ip deny. So it seems to me that the dialer-list command is good practice.
Also why have you configured dialer idle-timeout 0 ?
--Richard
-----Message d'origine-----
De : venkat garigipati [mailto:garigipati@yahoo.com]
Envoyi : Saturday, September 25, 2004 1:51 AM
@ : ccielab@groupstudy.com
Objet : ISDN Issue..
hi
The question is that R4 can call R5 but R5 is not allowed to call R4.. When I do this via a PING the call gets setup but I do not get a response...When I add the dialer-list/dialer-group commands to R5 it works. Below is my config. I am using c3640-js-mz.122-15.T14 image on both R4 & R5..How do I make Only one side initiate the call...?
R5:
-----
username r5 password CISCO
!
interface BRI0/0
ip address 187.1.45.5 255.255.255.0
dialer idle-timeout 0
dialer map ip 187.1.45.4 name r4 broadcast
isdn switch-type basic-ni
isdn spid1 22220101
end
R4:
-----
username r5 password CISCO
!
interface BRI0/0
ip address 187.1.45.4 255.255.255.0
dialer map ip 187.1.45.5 name r5 broadcast 22220101
dialer-group 1
isdn switch-type basic-ni
isdn spid1 11110101
end
!
dialer-list 1 protocol ip permit
---------------------------------
Do you Yahoo!?
Yahoo! Mail - 50x more storage than other providers!
This archive was generated by hypermail 2.1.4 : Fri Oct 01 2004 - 15:00:49 GMT-3