From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Thu Oct 21 2004 - 01:04:45 GMT-3
Issue the command "isdn test call interface bri2/0 4370443" on r4 twice.
If you can't get both channels up it's a problem with your layer 2
config.
HTH,
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> Cisco Net
> Sent: Wednesday, October 20, 2004 8:05 PM
> To: Group Study
> Subject: PPP multilink - not getting the second BRI [IE lab 7]
>
> Hi
> Part of the question is to get both BRI channels together.
> And i have the following configurations,
>
> Rack4R5:
> interface BRI2/0
> ip address 163.4.45.5 255.255.255.248
> ip router isis
> encapsulation ppp
> dialer map clns 33.0004.0004.0004.00 name Rack4R4 broadcast 2436155
> dialer map ip 163.4.45.4 name Rack4R4 broadcast 2436155
> dialer-group 1
> isdn switch-type basic-ni
> isdn spid1 4084370443
> ppp authentication chap
> ppp multilink --> Multilink is enabled
> ppp multilink links minimum 2 -->so that both channels should come up
> isis circuit-type level-2-only
>
> dialer-list 1 protocol ip permit
> dialer-list 1 protocol clns_is permit
>
> Rack4R4:
>
> interface BRI3/0
> ip address 163.4.45.4 255.255.255.248
> ip router isis
> encapsulation ppp
> dialer idle-timeout 0
> dialer map clns 33.0005.0005.0004.00 name Rack4R5 broadcast 4370443
> dialer map ip 163.4.45.5 name Rack4R5 broadcast 4370443
> isdn switch-type basic-ni
> isdn spid1 4082436155
> ppp authentication chap
> ppp multilink --------> mullink enabled
> isis circuit-type level-2-only
>
> Only R5 have the " ppp multilink links minimum 2" and that is beacuse
> only R5 is allowed to dial and establish. There is no DDR on R4.
>
> R5:
> Sh ip in brief shows second channel is still down.
> BRI2/0 163.4.45.5 YES NVRAM up
> up
> BRI2/0:1 unassigned YES unset up
> up
> BRI2/0:2 unassigned YES unset down
> down
>
> Any inputs are appreciated
> Regards
> Cert
>
>
This archive was generated by hypermail 2.1.4 : Sat Nov 06 2004 - 17:11:50 GMT-3