From: Dillon Yang (gzdillon@hotmail.com)
Date: Wed Mar 16 2005 - 03:52:16 GMT-3
Hi, all
Is it possible to crossover two BRI interface without simulator like the T1?
TIA
dillon
----- Original Message -----
From: "Edwards, Andrew M" <andrew.m.edwards@boeing.com>
To: "Hans None" <acsyao@hotmail.com>; <ccielab@groupstudy.com>
Sent: Wednesday, March 16, 2005 1:41 AM
Subject: RE: how can I connect two routers with built-in T1 CSU/DSU?
> Pins 1-2 cross to pins 4-5 on the cable between the RJ48C connectors.
>
> Andy
>
> -----Original Message-----
> From: Hans None [mailto:acsyao@hotmail.com]
> Sent: Tuesday, March 15, 2005 9:15 AM
> To: ccielab@groupstudy.com
> Subject: how can I connect two routers with built-in T1 CSU/DSU?
>
>
> All,
>
>
> I have two routers with built-in T1 csu/dsu, the interface is like the
> RJ-45
> scoket, how can I connect those two routers? Do I have to change the pin
>
> config for the ehternet cable to accomplish?
>
> Thanks,
>
> hans
>
> _________________________________________________________________
> Is your PC infected? Get a FREE online computer virus scan from McAfee.
> Security. http://clinic.mcafee.com/clinic/ibuy/campaign.asp?cid=3963
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Apr 03 2005 - 17:56:46 GMT-3