From: mani poopal (mani_ccie@yahoo.com)
Date: Mon May 09 2005 - 14:09:22 GMT-3
Hi Group,
The question in the book is
"configure CAR on R6 a3/0, so that web traffic will be sent but using ip precdence 5 for web traffic that conforms to the first rate policy, non conforming web traffic uses ip precedence 0. Any remaining traffic is limited to 8mbps, with normal burst size of 16,000 bytes and an excess burst size of 24000 bytes. Traffic that conforms should sent with ip precedence 5 and traffic that does not conform should be dropped"
solution in the book:
int atm3/0
rate-limit output access-group 101 20000000 24000 32000 confrom-action set-prec-transmit 5 exceed-action set-prec-trasnmit 0
rate-limit output 8000000 16000 24000 confrom-action set-prec-transmit 5 exceed-action drop
access-list 101 permit tcp any any eq www
Guys, I have 2 questions:
1. for the first rate policy the limit is not given
2. I think the first rate policy statement should be
"rate-limit output access-group 101 20000000 24000 32000 conform-action set-prec-transmit 5 exceed-action set-prec-continue 0
So the question is is set-prec-transmit 5 is right or it should be set-prec-continue 0, I think later is right because if you don't put continue it wont read the second rate-limit statement. Any suggestions are appreciated, I would be happy if scott, Brian or Marveen comes to give any suggestions to this doubt.
Again thanks a lot for all the answers.
thanks
Mani
B.ENG,A+,CCNA,CCNP,CCNP-VOICE, CSS1,CNA,MCSE
(416)431 9929
MANI_CCIE@YAHOO.COM
---------------------------------
Yahoo! Mail Mobile
Take Yahoo! Mail with you! Check email on your mobile phone.
This archive was generated by hypermail 2.1.4 : Fri Jun 03 2005 - 10:11:57 GMT-3