From: Sean C (Upp_and_Upp@hotmail.com)
Date: Fri Jun 03 2005 - 13:42:48 GMT-3
I had suggested the info below but the only response was from Simon who 
thought it was worth a shot:
A new feature for eBGP and iBGP load-balancing:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/122t/122t4/fteibmpl.htm#wp1027129
The Doc says it's only for MPLS VPNs - but maybe it can work for the 
scenario.
Sean
----- Original Message ----- 
From: "ccie2be" <ccie2be@nyc.rr.com>
To: "'Group Study'" <ccielab@groupstudy.com>
Sent: Friday, June 03, 2005 12:08 PM
Subject: RE: BGP Load-balancing betw ibgp and ebgp paths
> Last week there was some discussion about this but I don't think it was 
> ever
> resolved.  Has anyone thought of a way to load-balance between ibgp and 
> ebgp
> learned routes?
>
> TIA, Tim
> -----Original Message-----
> From: ccie2be [mailto:ccie2be@nyc.rr.com]
> Sent: Friday, May 27, 2005 4:58 AM
> To: Group Study
> Subject: BGP Load-balancing betw ibgp and ebgp paths
>
> Hi guys,
>
> I now know how to configure BGP to load-balance between paths learned from
> either multiple ebgp peers or from multiple ibgp peers.
>
> maximum-paths #  --- for ebgp peers
>
> maximum-paths ibgp # -- for ibgp peers
>
>
> But, how is load balancing configured when the same route is learned from
> both an ibgp and an ebgp peer?
>
> I looked at all the bgp commands available under the bgp process but none
> appear to do the trick.
>
> Any ideas?
>
> TIA, Tim
>
> R6(config-router)#bgp ?
>  always-compare-med      Allow comparing MED from different neighbors
>  bestpath                Change the default bestpath selection
>  client-to-client        Configure client to client route reflection
>  cluster-id              Configure Route-Reflector Cluster-id
>  confederation           AS confederation parameters
>  dampening               Enable route-flap dampening
>  default                 Configure BGP defaults
>  deterministic-med       Pick the best-MED path among paths advertised 
> from
>                          the neighboring AS
>  dmzlink-bw              Use DMZ Link Bandwidth as weight for BGP
> multipaths
>  fast-external-fallover  Immediately reset session if a link to a directly
>                          connected external peer goes down
>  inject-map              Routemap which specifies prefixes to inject
>  log-neighbor-changes    Log neighbor up/down and reset reason
>  redistribute-internal   Allow redistribution of iBGP into IGPs 
> (dangerous)
>  router-id               Override configured router identifier
>  scan-time               Configure background scanner interval
>
> R6(config-router)#bgp best ?
>  compare-routerid  Compare router-id for identical EBGP paths
>  dampening         Enable route-flap dampening
>  dmzlink-bw        Use DMZ Link Bandwidth as weight for BGP multipaths
>  inject-map        Routemap which specifies prefixes to inject
>  med               MED attribute
>  scan-time         Configure background scanner interval
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Anti-Virus.
> Version: 7.0.308 / Virus Database: 266.11.15 - Release Date: 22-May-05
>
>
> -- 
> No virus found in this outgoing message.
> Checked by AVG Anti-Virus.
> Version: 7.0.308 / Virus Database: 266.11.15 - Release Date: 22-May-05
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:40 GMT-3