From: Bob Sinclair (bsinclair@netmasterclass.net)
Date: Wed Jun 15 2005 - 14:22:51 GMT-3
Thomwin,
No, do not configure the command "frame-relay traffic-shaping" when doing
MQC-based shaping. When doing MQC-based shaping remember that the "shape
average" command automatically sets Be equal to Bc, so set Be explictly to 0
if the task does not require an excess burst. Also remember that if you want
to shape at the DLCI level, using a map-class frame-relay, then you must shape
class class-default.
HTH,
Bob Sinclair
CCIE #10427, CCSI 30427, CISSP
www.netmasterclass.net
----- Original Message -----
From: Thomwin Chen
To: ccielab@groupstudy.com
Sent: Wednesday, June 15, 2005 1:02 PM
Subject: MQC-Based FRTS
Hi All,
just want to confirm.
to configure MQC-Based FRTS, should I use frame-relay traffic-shaping
command in main interface ?
In CiscoDoc, MQC-Based FRTS don't have frame-relay traffic-shaping command
in main interface ??
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122newft/12
2t/122t13/frqosmqc.htm
thanks
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:41 GMT-3