Dialer profiles without dialer strings

From: ccie2be (ccie2be@nyc.rr.com)
Date: Sat Jun 25 2005 - 10:36:21 GMT-3

• Next message: ccie2be: "encap ppp not always needed on bri int"
• Previous message: Sila Moni: "RE: QoS - legacy priority convert to MQC"
• Next in thread: Montiean: "Re: Dialer profiles without dialer strings"
• Maybe reply: Montiean: "Re: Dialer profiles without dialer strings"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi guys,
 
Aside from not losing points on the lab, what are the "real world" reasons
one would use this config technique.
 
 
interface BRI0/0
 no ip address
 encapsulation ppp
 dialer rotary-group 0 <-- the 0 refers to int dialer 0 below
 dialer-group 1
 isdn switch-type basic-ni
 isdn spid1 5272014
!
interface Dialer0
 ip address 157.1.45.4 255.255.255.0
 encapsulation ppp
 dialer in-band <-- must have this instead of dialer pools
 dialer map ip 157.1.45.5 broadcast 5272015
 dialer-group 1
 
 
Also, notice that dialer-group 1 is configured on both the phy and the
dialer int. Why is that ?
 
TIA, Tim

• Next message: ccie2be: "encap ppp not always needed on bri int"
• Previous message: Sila Moni: "RE: QoS - legacy priority convert to MQC"
• Next in thread: Montiean: "Re: Dialer profiles without dialer strings"
• Maybe reply: Montiean: "Re: Dialer profiles without dialer strings"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Jul 06 2005 - 14:43:44 GMT-3