From: Scott Morris (swm@emanon.com)
Date: Mon Jul 25 2005 - 22:05:20 GMT-3
Depending on your IOS version, you can also use "frame-relay interface-dlce
(#) protocol ip (ip#)" in order to map to the other side.
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fwan
_r/frcmds/wrffr2.htm#wp1029352
But other than that, PPPoFR would be something worth looking at.
Scott
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Schulz, Dave
Sent: Monday, July 25, 2005 11:19 AM
To: Bob Sinclair; ccielab@groupstudy.com
Subject: RE: Frame Question
Thanks, Bob.....They limit you in the lab to using 2 subinterfaces to do
this on R2 (one is already a point to point, which is working). They state
"Do not use map statements on R2". Is there a way to accomplish this using
a class map and map-lists? Or, could this be an error on the lab? I'll was
going to try the sub interface on two point to points, but it didn't look
right considering I only have one subnet.
Dave Schulz, CCDP, CCNP, CCSP
Project Manager / TAC Supervisor
Data Processing Sciences Corporation
10810 Kenwood Road
Cincinnati, Ohio 45242
Phone - (513) 791-7100 ext.7411
Fax - (513) 791-4676
Email: dschulz@dpsciences.com <mailto:dschulz@dpsciences.com%20>
________________________________
From: Bob Sinclair [mailto:bsinclair@netmasterclass.net]
Sent: Monday, July 25, 2005 10:56 AM
To: Schulz, Dave; ccielab@groupstudy.com
Subject: Re: Frame Question
Dave,
Seems to me that if your frame-relay interface is multipoint (physical or
subif), then mapping is required (either static or dynamic). If both static
and dynamic mapping is ruled out, then you must use point-to-point
subinterfaces. Does the scenario explicity rule out p-p subifs? Have you
considered puttiing the same subnet on two p-p subifs?
HTH,
Bob Sinclair
CCIE #10427, CCSI 30427, CISSP
www.netmasterclass.net
----- Original Message -----
From: Schulz, Dave <mailto:DSchulz@dpsciences.com>
Sent: Monday, July 25, 2005 10:46 AM
Subject: Frame Question
I have a lab question that has a multipoint frame terminating at
R2 with
two DLCIs going to two different routers. You must disable inverse
arp,
and must use sub-interfaces. The last catch on this is .....
You cannot
use the map statement. This makes it so you can only use the
frame-relay interface-dlci command. However, this won't work for
mapping to the IP address at each location. Any ideas on how to
make
this one work? Everything on the doc cd for static mapping on a
multipoint requires map statements. Hmmmm.
Dave Schulz,
Email: dschulz@dpsciences.com <mailto:dschulz@dpsciences.com >
This archive was generated by hypermail 2.1.4 : Sun Sep 04 2005 - 17:00:31 GMT-3