From: Edwards, Andrew M (andrew.m.edwards@boeing.com)
Date: Mon Oct 17 2005 - 20:05:47 GMT-3
Manoj,
If you want to mark FR DE with MQC for rates over an amount, look
towards policing options.
Give it a whirl!
HTH,
Andy
-----Original Message-----
From: manoj menon [mailto:manojmenon123@yahoo.com]
Sent: Sunday, October 16, 2005 7:21 AM
To: ccielab@groupstudy.com
Subject: FR-Discard Eligible
Hi Group,
IF we set de using MQC or de-list for all IP traffic, will it set all
the time (despite the fact there is a congestion or not) ??
From the FR command reference, I see the following:
frame-relay de-list list-number {protocol protocol | interface type
number} characteristic
charasteristic points to the following options:
fragmentsFragmented IP packets
gt bytesSets the DE bit for packets larger than the specified number of
bytes (including the 4 byte Frame Relay Encapsulation) list
access-list-numberPreviously defined access list number lt bytesSets
the DE bit for packets smaller than the specified number of bytes
(including the 4 byte Frame Relay Encapsulation) tcp portTCP packets to
or from a specified port udp portUser Datagram Protocol (UDP) packets
to or from a specified port
However, if we want to mark a traffic above a certain rate, say 12Kbps,
how do we do this?
Do you think I should look for 'fragmentation and then mark DE for all
fragments ??
Any advice will be greatly appreciated.
Thanks & Regards,
Manoj
---------------------------------
Yahoo! Music Unlimited - Access over 1 million songs. Try it free.
This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:51 GMT-3