Re: OSPF loopback addresses shown as real subnet

From: Anthony Sequeira (terry.francona@gmail.com)
Date: Wed Oct 19 2005 - 18:11:06 GMT-3

• Next message: Andrew Lissitz \(alissitz\): "RE: CCIE lab"
• Previous message: Anthony Sequeira: "Re: CCIE lab"
• Maybe in reply to: pauls@hostworks.com.au: "OSPF loopback addresses shown as real subnet"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Option 2 - Redistribution - if you redistribute the loopback in using the
redistribute connected syntax that does the trick
 Option 3 - Area Range Command - you can summarize the loopback address so
it shows up to other routers with the proper mask.

 On 10/19/05, pauls@hostworks.com.au <pauls@hostworks.com.au> wrote:
>
> Hi,
>
> I know that there are 3 ways to get loopback addresses into ospf with
> there real subnet 1 way is ip ospf network point-to-point what are the
other
> 2?
>
> regards Paul
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

• Next message: Andrew Lissitz \(alissitz\): "RE: CCIE lab"
• Previous message: Anthony Sequeira: "Re: CCIE lab"
• Maybe in reply to: pauls@hostworks.com.au: "OSPF loopback addresses shown as real subnet"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Nov 06 2005 - 22:00:51 GMT-3