From: Daniel Kutchin (daniel@kutchin.com)
Date: Fri Nov 11 2005 - 23:24:21 GMT-3
ODR doesn't seem to work for me.
r1 ---- r2 (hub)
r1:
interface e0
ip add 172.16.0.0.1 255.255.0.0
!
int s0.1
ip add 192.168.5.1 255.255.255.252
fram int 102
!
router odr
r2:
interface e0
ip add 192.168.0.2 255.255.255.0
!
int s0.1
ip add 192.168.5.2 255.255.255.252
fram int 201
!
router odr
---
r1#sh cdp n
Capability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge
S - Switch, H - Host, I - IGMP, r - Repeater
Device ID Local Intrfce Holdtme Capability Platform Port ID
sw1 Eth 0 125 S I WS-C2950-1Fas
0/3
r2 Ser 0.1 158 R S 2611 Ser
0/0.1
---
r1#debug cdp ip
02:16:08: CDP-IP: IP TLV length (4) invalid for IP prefixes.
Expecting IP prefix from stub router
r1#
02:16:42: CDP-IP: Aging routes
02:16:42: CDP-IP: Writing default route 172.16.0.1 for Ethernet0
02:16:42: CDP-IP: Writing default route 192.168.5.1 for Serial0.1
r1#
02:17:08: CDP-IP: IP TLV length (4) invalid for IP prefixes.
Expecting IP prefix from stub router
---
- Using c2500-is-l.122-15.T17.bin
- Both R1 and R2 give the same error messages
- no odr routes found
- have tried classful addresses too
- Have search the Cisco website
- Have searched Groupstudy archive. There was a similar thread
in March. Someone referred to a link but it is broken.
Any ideas please?
Daniel
This archive was generated by hypermail 2.1.4 : Thu Dec 01 2005 - 09:12:06 GMT-3