From: James Ventre (messageboard@ventrefamily.com)
Date: Mon Dec 05 2005 - 19:22:23 GMT-3
Did you have the VTP domains set yet?
(in desirable the names must match)
James
Schulz, Dave wrote:
> Dave -
>
> Yes, I tried that with similar results. New information.... I set the speed
> and duplex on both port-channels and everything started working. very
> strange. Thanks
>
> Dave
>
> -----Original Message-----
> From: Dave Meyer
> To: Schulz, Dave
> Sent: 12/5/2005 4:31 PM
> Subject: Re: Etherchannel issues
>
> can you set the mode to desirable on CAT2 ?
>
> Regards,
> Dave
> ______________________________________________
> Architecture & Engineering
> Work: (201) 593-5545
> Cell: (973) 907-4963
>
>
>
>
>
> "Schulz, Dave" <DSchulz@dpsciences.com>
> Sent by: nobody@groupstudy.com
> 12/05/2005 03:10 PM
> Please respond to "Schulz, Dave"
>
>
> To: <ccielab@groupstudy.com>
> cc:
> Subject: Etherchannel issues
>
>
> I know I have done this a million times before, but am running into some
> issues. I am setting up vtp server/client between two cats with
> etherchannel,
> using fa0/13 and fa0/14 and having problems. Here is a section of the
> show
> etherchannel detail (I am trying to find more info on the flags on docCD
>
> and
> not finding it)....
>
> Local information:
> Hello Partner PAgP Learning
> Group
> Port Flags State Timers Interval Count Priority Method
> Ifindex
> Fa0/14 SAC U6/S7 HQ 30s 1 128 Any 29
>
>
> Here is the config....
> CAT1.....
> !
> interface Port-channel1
> switchport trunk encapsulation dot1q
> switchport mode trunk
> !
> (output omitted)
> !
> interface FastEthernet0/13
> switchport trunk encapsulation dot1q
> switchport mode trunk
> channel-group 1 mode desirable
> !
> interface FastEthernet0/14
> switchport trunk encapsulation dot1q
> switchport mode trunk
> channel-group 1 mode desirable
> !
>
> CAT2....
>
> interface Port-channel1
> switchport trunk encapsulation dot1q
> switchport mode trunk
> !
> (output omitted)
> !
> interface FastEthernet0/13
> switchport trunk encapsulation dot1q
> switchport mode trunk
> channel-group 1 mode auto
> !
> interface FastEthernet0/14
> switchport trunk encapsulation dot1q
> switchport mode trunk
> channel-group 1 mode auto
> !
>
> The vlan information is not being sent from CAT1 to CAT2 through VTP.
> Maybe
> this is a bug in the software? Maybe I'm just missing something. Is
> there
> some strange order that needs to happen to initiate the etherchannel?
>
> Dave
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Mon Jan 09 2006 - 07:07:50 GMT-3