From: Balogh, Jim (jim.balogh@gwl.com)
Date: Wed Feb 15 2006 - 14:33:51 GMT-3
Please see configuration below. I am trying to get a handle on the Shaping
Queue, Interface Software Queue and TX ring. If I wanted to configure the
Shaping Queue with one LLQ for VoIP, and remaining traffic to be moved into a
WFQ, and then the Software Interface Queue as a WFQ, will my config look like
this:
policy-map VOIP
class VOIP-RTP
priority 32 _ configures an LLQ within the
SHAPING QUEUE
class class-default
fair-queue _ configure WFQ within the SHAPING
QUEUE
policy-map SHAPE-ALL
class class-default
shape average 96000 960 _SHAPING Queue-shape to 96k with
Tc=10ms
service-policy VOIP _ apply VOIP policy to the SHAPING QUEUE
interface serial0/0
bandwidth 96
fair-queue _enable WFQ for the
SOFTWARE QUEUE
interface serial0/0.1
service-policy output SHAPE-ALL _ enable CB
Shaping
From my understanding, if the transmission rate is above the Shaping rate, the
packets will be moved into the Shaping Queue. Then the scheduler removes a
packet from the Shaping Queue (either a WFQ or LLQ if a VoIP packet is
waiting), and if the TX Ring is full the packet is moved to the Interface
Software Queue. In this case the Software Queue is a WFQ.
QUESTION - if I want the Shaping Queue to retain the same config, how can I
configure the Software Queue as CBWFQ? Thx.
Jim
This archive was generated by hypermail 2.1.4 : Wed Mar 01 2006 - 11:28:18 GMT-3