From: Bob Sinclair (bob@bobsinclair.net)
Date: Thu Feb 16 2006 - 23:32:40 GMT-3
Sami,
The most likely solution would be BSR, bootstrap router. It is similar to
Auto-RP, but instead of being a Cisco add-on protocol, it is built into PIM
version 2. Both Auto-RP and BSR have routers that are willing to be
rendezvous points (candidate RPs), and routers that collect and announce RP
information ("mapping agents" in Auto-RP, BSRs in the PIM standard).
Here are the necessary commands:
To configure candidate bsr: ip pim bsr-candidate loop0 [priority].
To configure candidate rp: ip pim rp-candidate loop0 [bidir] [group-list Y]
[priority Z].
Here is a link for more info:
http://www.cisco.com/univercd/cc/td/doc/cisintwk/intsolns/mcst_sol/rps.htm
HTH,
Bob Sinclair
CCIE #10427, CCSI 30427
www.netmasterclass.net
----- Original Message -----
From: Sami Salim
To: ccielab@groupstudy.com
Sent: Thursday, February 16, 2006 1:35 PM
Subject: Using Anycast RP
I am working on a practise lab which doesn't have answers. The multicast
section is asking to make sure a specific router in the domain to be the RP,
under the condition that I do not manually configure a static rp or auto-rp.
I wonder in this case, if MSDP is a valid solution.
Your input is appreciated.
---------------------------------
Find your next car at Yahoo! Canada Autos
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Wed Mar 01 2006 - 11:28:18 GMT-3