From: Brian McGahan (bmcgahan@internetworkexpert.com)
Date: Wed Mar 01 2006 - 14:57:14 GMT-3
When you apply a configuration to the port-channel interface the
member interfaces of the channel automatically inherit that
configuration.
HTH,
Brian McGahan, CCIE #8593
bmcgahan@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987 x 705
Outside US: 775-826-4344 x 705
24/7 Support: http://forum.internetworkexpert.com
Live Chat: http://www.internetworkexpert.com/chat/
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf
Of
> PANDI MOORTHY
> Sent: Wednesday, March 01, 2006 12:57 AM
> To: Cisco certification
> Subject: Trunk + Ether channel question.
>
> Hi Group,
>
>
>
>
>
> Trunk + Ether channel question.
>
>
>
> The question asks to configure the industry standard ether channel and
> trunk
> in there of the switch interfaces.
>
>
>
>
>
>
>
> The IE solution guide config as below:
>
>
>
> interface FastEthernet0/13
>
> channel-group 1 mode active
>
> !
>
> interface FastEthernet0/14
>
> channel-group 1 mode active
>
> !
>
> interface FastEthernet0/15
>
> channel-group 1 mode active
>
> !
>
> interface Port-channel1
>
> switchport trunk encapsulation dot1q
>
> switchport mode trunk
>
>
>
>
>
> 1) Based on the solution, the dot1q is configured only at the port
channel
> (LACP) interface. So the interface in this group will be automatically
be
> the trunk port, is it correct??
>
>
>
> 2) On other way, if the question asks to configure LACP port channel
with
> ISL trunk, can I follow the same setup, I mean just configure the
trunk at
> the port channel interface, will it be enough??
>
>
>
> Basically I am confused, on IE solution, for some scenario they apply
> trunk
> configuration at both port channel and FE interfaces. In the above
case
> applied only at the port channel interface.
>
>
>
>
> Sorry to sent many question, Please advice me.
>
> Regards.
> Pandi
>
>
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:37 GMT-3