From: Joshua Lauer (jslauer@hotmail.com)
Date: Fri Mar 24 2006 - 18:42:27 GMT-3
No permit 20 statement is needed, it will only 
Policy route what you want (i.e. specify in the 
route map)
JL
Joshua Lauer
CCNA, CCDA, CCNP, CCDP, CCSP, CCIP, RHCE, INFOSEC, 
CISSP, CEH
----- Original Message ----- 
From: "John Matus" <John.Matus@tokiom.com>
To: <ccielab@groupstudy.com>
Sent: Friday, March 24, 2006 4:28 PM
Subject: policy route question
> if you just want to policy route one kind of 
> traffic but not any other
> should you use a "permit 1000" statement to allow 
> the other traffic to pass
> thru or does the other traffic just know 
> intuitively not to be policy
> routed if it does not match the ACL in the 
> route-map
>
> EXAMPLE
>
> route-map policy permit 10
> match ip address 111
> set ip next-hop 132.1.23.3
> !
> route-map policy permit 20
>
> should i used the "permit 20" or not?
>
>
> Regards,
>
> John D. Matus
> Technical Support / PAS
> Fujitsu Consulting
> 626-568-7716
> John.Matus@tokiom.com
> ========================================================================================================
>   This  e-mail  is  intended  solely  for  the 
> individual  to  whom it is
> addressed.   The   information  contained  in 
> this  transmission  contains
> confidential  and/or proprietary information or is 
> otherwise privileged. If
> the reader of this message is not the intended 
> recipient, please be advised
> that  any  dissemination,  distribution  or 
> copying of this transmission is
> strictly  prohibited.  If  you  have  received 
> this e-mail in error, please
> notify  us immediately by returning it to the 
> sender and deleting this copy
> from     your     system.     Thank     you 
> for    your    cooperation.
> ========================================================================================================
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sat Apr 01 2006 - 10:07:40 GMT-3