Re: IOS Image

From: Scott Thornton (scthornton@gmail.com)
Date: Tue Apr 04 2006 - 13:29:59 GMT-3

I would suggest stepping through the Software Advisor on Cisco TAC...that
will help you determine which features are available in which IOS and how
much memory/flash you will need.

http://www.cisco.com/public/support/tac/tools.shtml

HTH

Scott C Thornton
http://www.scthornton.com

On 4/4/06, b1t AvAtAr <b1t.avatar@gmail.com> wrote:
>
> Hi Guys, please could anyone support me on this One, Which IOS Image
> should
> I use to support IPV6 in this 2522 Router
>
> FRS-BB2#conf te
> Enter configuration commands, one per line. End with CNTL/Z.
> FRS-BB2(config)#interface Loopback0
> FRS-BB2(config-if)# ip address 220.20.3.1 255.255.255.0
> FRS-BB2(config-if)# ipv6 address 2001:220:20:3::1/64
> ^
> % Invalid input detected at '^' marker.
>
> FRS-BB2(config-if)# ipv6 rip RIPng enable
> ^
> % Invalid input detected at '^' marker.
>
> FRS-BB2(config-if)#!
> FRS-BB2(config-if)#interface Loopback1
> FRS-BB2(config-if)# ip address 222.22.2.1 255.255.255.0
> FRS-BB2(config-if)# ipv6 address 2001:222:22:2::1/64
> ^
> % Invalid input detected at '^' marker.
>
> FRS-BB2(config-if)# ipv6 rip RIPng enable
> ^
> % Invalid input detected at '^' marker.
>
> FRS-BB2(config-if)#!
> FRS-BB2(config-if)#interface Loopback3
> FRS-BB2(config-if)# ip address 205.90.31.1 255.255.255.0
> FRS-BB2(config-if)# ipv6 address 2001:205:90:31::1/64
> ^
> % Invalid input detected at '^' marker.
>
> FRS-BB2(config-if)# ipv6 rip RIPng enable
> ^
> % Invalid input detected at '^' marker.
>
> FRS-BB2(config-if)#!
> FRS-BB2(config-if)#interface Loopback51515151
> FRS-BB2(config-if)# ip address 51.51.51.51 255.255.255.255
> FRS-BB2(config-if)# ipv6 address 2001:51:51:51::51/64
> ^
> % Invalid input detected at '^' marker.
>
> FRS-BB2(config-if)#
> FRS-BB2(config-if)#do show ver
> ^
> % Invalid input detected at '^' marker.
>
> FRS-BB2(config-if)#^Z
> FRS-BB2#show ver
> Cisco Internetwork Operating System Software
> IOS (tm) 2500 Software (C2500-JS-L), Version 12.2(27), RELEASE SOFTWARE
> (fc3)
> Copyright (c) 1986-2004 by cisco Systems, Inc.
> Compiled Tue 02-Nov-04 22:01 by kellmill
> Image text-base: 0x0307D390, data-base: 0x00001000
>
> ROM: System Bootstrap, Version 11.0(10c), SOFTWARE
> BOOTLDR: 3000 Bootstrap Software (IGS-BOOT-R), Version 11.0(10c), RELEASE
> SOFTWARE (fc1)
>
> FRS-BB2 uptime is 5 days, 14 hours, 35 minutes
> System returned to ROM by reload
> System image file is "flash:/c2500-js-l.122-27.bin"
>
> cisco 2522 (68030) processor (revision M) with 14336K/2048K bytes of
> memory.
> Processor board ID 14512161, with hardware revision 00000003
> Bridging software.
> X.25 software, Version 3.0.0.
> SuperLAT software (copyright 1990 by Meridian Technology Corp).
> TN3270 Emulation software.
> Basic Rate ISDN software, Version 1.1.
> 1 Ethernet/IEEE 802.3 interface(s)
> 2 Serial network interface(s)
> 8 Low-speed serial(sync/async) network interface(s)
> 1 ISDN Basic Rate interface(s)
> 32K bytes of non-volatile configuration memory.
> 16384K bytes of processor board System flash (Read ONLY)
>
> Configuration register is 0x2102
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
> 

--
Scott C Thornton

Notice: This e-mail (including attachments) is covered by the Electronic
Communications Privacy Act, 18 U.S.C. 2510-2521, is confidential and may be
legally privileged.  If you are not the intended recipient, you are hereby
notified that any retention, dissemination, distribution, or copying of this
communication is strictly prohibited.  Please reply to the sender that you
have received the message in error, then delete it.  Thank you.

This archive was generated by hypermail 2.1.4 : Mon May 01 2006 - 11:41:56 GMT-3