From: Brian Dennis (bdennis@internetworkexpert.com)
Date: Sun Jun 04 2006 - 15:08:16 ART
Remember in the lab don't try and think about the "best way" to do
something. Do whatever you need to do to meet the requirements of the
lab and nothing more. If they want the loopback in OSPF but don't have
any restrictions on how to get it in, then they don't care how you got
it in. They just care that it's in OSPF.
Think about it like this. If you gave someone a lab to do and told them
to advertise a loopback into OSPF without any restrictions, how would
you grade it? More than likely it would be something along the lines of
"show ip route ospf | include X.X.X.X" on a neighboring OSPF enabled
router. Compare that to hunting through the router's configuration to
figure out how they solved the task (network statement, redistribution,
etc).
HTH,
Brian Dennis, CCIE #2210 (R&S/ISP-Dial/Security)
bdennis@internetworkexpert.com
Internetwork Expert, Inc.
http://www.InternetworkExpert.com
Toll Free: 877-224-8987
Direct: 775-745-6404 (Outside the US and Canada)
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Sami
Sent: Sunday, June 04, 2006 8:01 AM
To: Cisco certification
Subject: ospf
What is the best way of advertising loopback address in ospf , via
network
command or redistribute connected command ?
I always use network command but I have seen some of workbook use
redistribut connected for loopbacks.
Thanks in advance.
Sami
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:31 ART