From: Kulcsár
Date: Tue Jun 27 2006 - 07:33:06 ART
Hi Sami,
What about setting broadcast mode on the hub router and change the hello interval to 30 sec on the hub router's serial interface?
Andras
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Sami
Sent: Tuesday, June 27, 2006 12:14 PM
To: ccielab@groupstudy.com
Subject: OSPF on NMBA
Group,
There is Hub and spoke FR NBMA network. R5 is Hub and using inverse ARP , R1 and R2 spokes no FR inverse arp , use frame-relay map command to reach hub.
Task say enable OSPF area 0 on R5,R1 and R2 don't use neighbour command on R5 to accomplish this and do not use any interface level command on R1 and R2 to accomplish this.
I can't change interface type to polint to multipoint on R1 and R2 and on R5 I can not use neighbour command. I don't think of any other solution to make it work.
What could be the solution for this task ? unfortunately solution guide doesn't say anything...
Thanks
This archive was generated by hypermail 2.1.4 : Sat Jul 01 2006 - 07:57:33 ART