From: srdja blagojevic (srdja1@pexim.co.yu)
Date: Fri Sep 01 2006 - 11:12:23 ART
Aamir,
do you have some virtual-link configuration under ospf?
Once (when I try to lab it IEWB lab 1 at my poor home lab) I noticed that if
I enter virtual link config first, and then neighbor statement, I got the
same output (OSPF: Neighbor command is allowed only on NBMA and
point-to-multipoint networks).
But when I entered these commands in reverse order (first neighbor, than
virtual link), then everything was ok.
HTH,
Srdja
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Aamir Aziz
Sent: Friday, September 01, 2006 14:57
To: ccielab@groupstudy.com
Subject: Weird problem with OSPF
HI there ppl,
I have a hub and spoke environment like this R2-------R5-------R3,
R5 is the hub with s0/0.235 multipoint interface meaning by default NBMA
mode, which requires neighbor command on R5 but when i reboot R5 i get this
error :
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
networks
OSPF: Neighbor command is allowed only on NBMA and point-to-multipoint
networks
and the neighbor command is no longer there in OSPF of R5, what is happening
here?? i have given ip ospf priority 0 on R2 and R3 to R5 as DR
Thanks
Aamir
This archive was generated by hypermail 2.1.4 : Sun Oct 01 2006 - 16:55:39 ART