From: graham@cisco-engineer.com
Date: Sat Feb 03 2007 - 14:06:09 ART
Hi group,
I'm working on a question which asks to load balance between two switch
endpoints 1 and 4
The layout is
----------------- SW3------------
SW1< >SW4
----------------SW2--------------
Question in its self is not hard but the sting is, where you have a choice
you must prefer source/destination ip Balancing?
Now the load balance method that came to mind was a Layer 3 etherchannel and
port-channel load balancing, but I can't see how that would fit in this
scenario? Should I ignore the bit at the end which stipulates where you have
a choice?
Thanks
Graham
This archive was generated by hypermail 2.1.4 : Thu Mar 01 2007 - 07:38:45 ART