From: Edison Ortiz (edisonmortiz@gmail.com)
Date: Wed Mar 14 2007 - 10:26:07 ART
Check the 'show frame map' in R3. I bet you have some mappings from R2 on
S1/1
You need to disable inverse-arp for that DLCI.
----- Original Message -----
From: "Hossam Abbas" <habbas97@yahoo.com>
To: <ccielab@groupstudy.com>
Sent: Wednesday, March 14, 2007 8:20 AM
Subject: Internetwork expert v4 lab 1 Multicast
>I have a small question in Internetwork expert v4 lab 1 Multicast task 5.1
>in the Task 5.1 Verification
>
> Rack1R3#show ip pim neighbor
> PIM Neighbor Table
> Neighbor Interface Uptime/Expires Ver DR
> Address Prio/Mode
> 183.1.123.2 Serial1/0 00:01:55/00:01:18 v2 1 / S
> 183.1.123.2 Serial1/1 00:01:26/00:01:18 v2 1 / DR S
> 183.1.0.5 Serial1/1 00:01:39/00:01:18 v2 1 / S
>
> How R3 see neighbr R2 through int s1/1 although multicast routing is not
> enabled on R1, SW1, and SW4?
>
> thanks
>
>
>
> ____________________________________________________________________________________
> Never miss an email again!
> Yahoo! Toolbar alerts you the instant new Mail arrives.
> http://tools.search.yahoo.com/toolbar/features/mail/
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:51 ART