From: Marvin Greenlee (marvin@ipexpert.com)
Date: Sun Mar 25 2007 - 00:44:07 ART
Usually this happens with multiple context mode. (which will survive an
erase/reload)
Verify with "show mode".
Change back to "mode single" and you should be fine.
Marvin Greenlee, CCIE #12237 (R&S, SP, Sec)
Senior Technical Instructor - IPexpert, Inc.
"When Will You Be an IP Expert?"
marvin@ipexpert.com
http://www.IPexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Tony
Schaffran
Sent: Saturday, March 24, 2007 9:39 PM
To: ccielab@groupstudy.com
Subject: OT:ASA troubles
I am just getting familiar with the ASA'a and experiencing a problem.
After a write erase and reload, when I go into the interfaces, there is no
option to configure an IP or nameif.
Is the ASA is some kind of non-standard mode? Can somebody assist to get it
back to normal state?
Much appreciated.
Tony Schaffran
Network Analyst
CCIE #11071
CCNP, CCNA, CCDA,
NNCDS, NNCSS, CNE, MCSE
www.cconlinelabs.com <http://www.cconlinelabs.com/>
Your #1 choice for online Cisco rack rentals.
This archive was generated by hypermail 2.1.4 : Sun Apr 01 2007 - 06:35:52 ART