From: Skinner, Stephen (Stephen.Skinner@rbs.co.uk)
Date: Sun May 06 2007 - 08:48:20 ART
Hello ,
My scenario,
I have a serial interface , with a multipoint sub interface and a point-to
point sub-interface configured
Q says ,
Configure FRTS for all DLCI`s .
Which would you do ..??
Apply it on the main int or apply it on all the subinterfaces ?
1.
Int s0/0
Frame-relay traffic shaping
Frame-relay class Steve
Map-class frame-relay Steve
Frame-realy cir 521000
2.
Int s0/0
Frame-relay traffic-shapping
Int s0/0.1 multipoint
Frame-relay class Steve
Int s0/0.2 point-to-point
Frame-relay class Steve
When I look at a "show frame-relay pvc" is see the same results .
Which do you guys recon is "best practise for the lab" ??
Cheers
Stephen Skinner
The Royal Bank of Scotland plc, Registered in Scotland No. 90312. Registered Office: 36 St Andrew Square, Edinburgh EH2 2YB
Authorised and regulated by the Financial Services Authority.
This e-mail message is confidential and for use by the addressee only. If the message is received by anyone other than the addressee, please return the message to the sender by replying to it and then delete the message from your computer. Internet e-mails are not necessarily secure. The Royal Bank of Scotland plc does not accept responsibility for changes made to this message after it was sent.
Whilst all reasonable care has been taken to avoid the transmission of viruses, it is the responsibility of the recipient to ensure that the onward transmission, opening or use of this message and any attachments will not adversely affect its systems or data. No responsibility is accepted by The Royal Bank of Scotland plc in this regard and the recipient should carry out such virus and other checks as it considers appropriate.
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:20 ART