From: subodh.rawat@wipro.com
Date: Mon Aug 20 2007 - 11:39:12 ART
Your router's F1/0 is connected to Switch F0/5. If you shut
administratively down router interface, Switch interface will also be
down (line protocol only).
Issue no keepalive at switch interface, then you should not have this
problem.
But why is this strange?
Subodh
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
NITIN NITIN
Sent: Monday, August 20, 2007 7:49 PM
To: ccielab@groupstudy.com
Subject: ethernet link not comming up
Hi ,
I have a issue which i strange for me
R5 fa1/0--------------F0/5 -SW1
R5#sh run int fa 1/0
Building configuration...
Current configuration : 72 bytes
!
interface FastEthernet1/0
no ip address
duplex full
speed 100
end
R5#sh isp inh it p inbrt br | i| i 1/10 /0
FastEthernet1/0 unassigned YES NVRAM up
down<<<
SW1#sh run int fa 0/5
Building configuration...
Current configuration : 110 bytes
!
interface FastEthernet0/5
switchport access vlan 2005
switchport mode access
speed 100
duplex full
end
SW1#sh ip int brief | i 0/5
FastEthernet0/5 unassigned YES unset up
up<<<<<<<<SW int up
If I shut interface on R5 =====
R5(config-if)#
*Aug 20 14:10:58.411: %LINK-5-CHANGED: Interface FastEthernet1/0,
changed state to administratively down
port on SW1 goes down 0-=-----
Aug 20 14:10:14: %LINK-3-UPDOWN: Interface FastEthernet0/5, changed
state to down
Regard
---------------------------------
Choose the right car based on your needs. Check out Yahoo! Autos new
Car Finder tool.
This archive was generated by hypermail 2.1.4 : Sat Sep 01 2007 - 11:32:12 ART