From: Farrukh Haroon (farrukhharoon@gmail.com)
Date: Sun Dec 30 2007 - 10:58:40 ARST
Perhaps it is in light-weight mode? You cannot go into global config mode on
those units. They are supposed to be managed by a WLAN Controller. You can
tell this even from the part number at the back of the unit (AIR-LAP123X).
Pre-Sales/Sales guys often make mistakes while ordering access-points :) (no
offense intended)
There are some wacky ways to convert it back to Autonomous mode, but if the
product is under warranty, speak to Cisco (or the selling party) about this.
Regards
Farrukh
On Dec 30, 2007 3:51 PM, CCIE <ccie@axizo.com> wrote:
> Dear Experts,
>
>
>
> I have a new Cisco AP 1232, IOS 12.3(7). But I can't access the global
> configuration of it, or even accessing it through the WEB.
>
> Anybody facing the same problem, or have an advice of that?
>
>
>
> Thanks all
>
> Amin
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Jan 01 2008 - 12:04:32 ARST