From: Gupta, Gopal (NWCC) (gopal.gupta@hp.com)
Date: Sun Jan 13 2008 - 06:02:31 ARST
Yes you are right this is trunk port, so you meant to say it is enabled
for trunk ports by default???which should not be the case....anyway i
will check it once again today evening,
Thanks for your input
Gops
________________________________
From: Mounir Mohamed [mailto:mounir.mohamed@gmail.com]
Sent: Sunday, January 13, 2008 13:28
To: Gupta, Gopal (NWCC)
Cc: ccielab@groupstudy.com
Subject: Re: BPDU Filter enabled by default on 3560 ??????
NO BPDU-FIlter disabled by default, the below show spanning-tree
interface x/x detail from one of 3560 catalysts with default
configurations, i beleive there is something wrong in your
configurations, because the received BPDU is so high which is not normal
unless the port is trunk, so please check your config because by default
the BPDU-Filter/Guard is disbaled.
Port 6 (FastEthernet0/4) of VLAN0020 is forwarding
Port path cost 19, Port priority 128, Port Identifier 128.6.
Designated root has priority 32788, address 001b.904f.cc00
Designated bridge has priority 32788, address 001b.904f.cc00
Designated port id is 128.6, designated path cost 0
Timers: message age 0, forward delay 0, hold 0
Number of transitions to forwarding state: 1
The port is in the portfast mode
Link type is point-to-point by default
BPDU: sent 5978045, received 0
On Jan 12, 2008 9:20 AM, Gupta, Gopal (NWCC) <gopal.gupta@hp.com> wrote:
Hi Experts,
One Confusion in the Doc Cd, it is written that BPDU filtering
is
disabled by default as far as 3560's are concerned, but when i
see the
output of the sh span int f0/10 detail, it shows for every port
even if
it is trunk :-
Port 712 (Port-channel13) of VLAN0001 is forwarding
Port path cost 12, Port priority 128, Port Identifier 128.712.
Designated root has priority 32769, address 000b.46e5.1380
Designated bridge has priority 32769, address 000b.46e5.1380
Designated port id is 128.65, designated path cost 0
Timers: message age 1, forward delay 0, hold 0
Number of transitions to forwarding state: 1
Link type is point-to-point by default
Bpdu filter is enabled
internally<--------------------------------------------------Enabled
internally ??????
BPDU: sent 5, received 474
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:59 ARST