From: shiran guez (shiranp3@gmail.com)
Date: Sat Feb 16 2008 - 08:28:18 ARST
this question was answered in previous threads but I will answer it again,
the reflector port is used only on the 3550 due to the hardware design and
you should use an unused port on your switch as when you set a reflector
port the port will no longer be available for anything other then the SPAN
process. so it doesn't meter witch one as long as it is unused one.
Regards
On Thu, Feb 14, 2008 at 9:56 PM, Tapas Das <tapas_75@hotmail.com> wrote:
> I have 2 two 3550 Switches, one as a VTP server and other as VTP Client.
> My RSPAN VLAN is 6
>
> Switch A & Switch B are connected thru ports 1,2,3 & 4, configured as
> ether-channel. (trunk port)
>
> port 10 on switch A is the source port
> port 10 on switch B is the destination port
>
> When using the refelector-port command on Switch A, which port no. should
> I
> use.
>
> Thanx in advance.
>
>
> _________________________________________________________________
> Post ads for free - to sell, rent or even buy.www.yello.in
> http://ss1.richmedia.in/recurl.asp?pid=186
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
-- Shiran Guez MCSE CCNP NCE1 http://cciep3.blogspot.com http://www.linkedin.com/in/cciep3
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2008 - 16:54:48 ARST