RE: Router

From: reto_ccie (reto_ccie@myway.com)
Date: Mon May 26 2008 - 23:10:28 ART

Next message: Rehan Ali Waqas: "RE: RIP MD5 follies"
Previous message: atlantaccie@gmail.com: "CCIETalk.com - My CCIE Blog [OT]"
Maybe in reply to: Kiran Parashare: "Router"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Even X.25 is not part of current CCIE Lab, could be interesting, read about PAD.

http://www.cisco.com/en/US/docs/ios/11_3/dial/command/reference/drpad.html

"PAD and X.25 Connection Setup Commands

This chapter describes the commands used for configuring an internal packet assembler/disassembler (PAD) application to make connections with remote devices using the X.25 protocol.

You can configure an internal PAD in the following ways:

Use the x28 EXEC command to access and use the X.28 standard interface. After the x28 command is issued, you enter X.28 mode and the router prompt changes to an asterisk (*). From this mode, you can set X.3 PAD parameters. "

Regards

Victor.

--- On Mon 05/26, Kiran Parashare < kiran.ccie@gmail.com > wrote:
From: Kiran Parashare [mailto: kiran.ccie@gmail.com]
To: ccielab@groupstudy.com
Date: Tue, 27 May 2008 06:55:25 +0530
Subject: Router

Hello GS, i did typo mistake on "Router>x2" but dont know how to revert it. i did escap but its not coming back only * comes on the screen. Regards, Kiran _______________________________________________________________________ Subscription information may be found at: http://www.groupstudy.com/list/CCIELab.html>

Next message: Rehan Ali Waqas: "RE: RIP MD5 follies"
Previous message: atlantaccie@gmail.com: "CCIETalk.com - My CCIE Blog [OT]"
Maybe in reply to: Kiran Parashare: "Router"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Jun 02 2008 - 06:59:18 ART