RE: How do I simulate Up/down condition on a serial interface?

From: Lloyd Ardoin (Lloyd@TheWizKid.biz)
Date: Sat Aug 16 2008 - 19:14:11 ART

• Next message: Lala Lander: "How does set ip next-hop suppose to behave?"
• Previous message: Mohamed Tandou: "Filter route from ospf"
• Maybe in reply to: Lala Lander: "How do I simulate Up/down condition on a serial interface?"
• Next in thread: Lala Lander: "Re: How do I simulate Up/down condition on a serial interface?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

You could apply frame-relay end-to-end keepalives only on one side with
either bidirectional or request mode and that will simulate a down
connection.

Lloyd V Ardoin

Network Engineer

CCDA, CCNP, CCSP, GSEC, GCFW, CISSP

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Lala Lander
Sent: Saturday, August 16, 2008 4:55 AM
To: Cisco certification
Subject: How do I simulate Up/down condition on a serial interface?

thanks in advance Gurus!

Blogs and organic groups at http://www.ccie.net

• Next message: Lala Lander: "How does set ip next-hop suppose to behave?"
• Previous message: Mohamed Tandou: "Filter route from ospf"
• Maybe in reply to: Lala Lander: "How do I simulate Up/down condition on a serial interface?"
• Next in thread: Lala Lander: "Re: How do I simulate Up/down condition on a serial interface?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Sep 01 2008 - 08:15:31 ART