Re: Help with NAT-PT

From: Bill Eyer (beyer@optonline.net)
Date: Fri Aug 22 2008 - 06:50:45 ART

• Next message: Bill Mckenzie: "OT:VERY specific job description"
• Previous message: abderrahim sadki: "cisco dubai eid vacation date"
• Maybe in reply to: But Nicky: "Help with NAT-PT"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I think some versions of code are just buggy with Nat-PT. I have
usually had to disable cef on the router to make it work reliably, with
CEF enabled only every other ping works. This has to be a code bug.

Bill

But Nicky wrote:
> Hi you guys,
> I have resolved this problem by adding command in R1 (NAT-PT router), but I
> have not understood the nature of problem.
> My adding as below:
> R1:
> !
> interface serial0/0
> no ip cef
> !
> R4#ping 1414::1 re 100
>
> Type escape sequence to abort.
> Sending 100, 100-byte ICMP Echos to 1414::1, timeout is 2 seconds:
> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
> !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
> Success rate is 100 percent (100/100), round-trip min/avg/max = 4/19/112 ms
>
> Thanks,
> Butnguyen,
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net

• Next message: Bill Mckenzie: "OT:VERY specific job description"
• Previous message: abderrahim sadki: "cisco dubai eid vacation date"
• Maybe in reply to: But Nicky: "Help with NAT-PT"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Sep 01 2008 - 08:15:31 ART