From: Osamah Shaheen (ShaheenO@maaden.com.sa)
Date: Wed Sep 10 2008 - 19:57:09 ART
Dear GS,
IF I have asked to do the following task:
You may not use Auto-RP or statically assign RPs.
? Configure R6 to announce itself as a candidate bootstrap router. Set its priority value to be the
default value defined in RFC 5059.
? Configure R1 to announce itself as a candidate rendezvous point. The priority should be the same
as for R6.
My answer:
R1#show run | inc candidate
ip pim bsr-candidate Loopback0 0 192
R6#show run | inc candidate
ip pim rp-candidate Loopback0 priority 192
This is not work with me!!! any suggestion or explanaition for better understanding such situation.
Thanks.
Sam
--------------------------------------------------------------------------------
This message and any attachments are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you are NOT the intended recipient you should not use, copy, disclose or place any reliance on this e-mail or its contents, and immediately notify the sender by return e-mail and delete all copies of this e-mail from your system.
Statement and opinions expressed in this e-mail are those of the sender, and do not necessarily reflect MA'ADEN.
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Oct 04 2008 - 09:26:18 ART