From: Mark Stephanus Chandra (mark.chandra@gmail.com)
Date: Sat Oct 18 2008 - 23:32:54 ART
Dear Friends,
I just tried to input service policy command on interface fa0/1 in my
switch.
I wonder I cannot input service policy output, the command is rejected, but
the command accepted when I use service-policy input.
Anybody know why ?
interface FastEthernet0/1
switchport access vlan 1111
switchport mode access
switchport protected
switchport block multicast
service-policy input ron
end
Rack3SW1(config-if)#service-policy output ron
police command is not supported for this interface
Configuration failed!
Warning: Assigning a policy map to the output side of an interface not
supported
Regards
Mark Stephanus Chandra
IT Consultant
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Nov 01 2008 - 15:35:21 ARST