RE: Regarding Virtual Template

One thing to consider if you want to redistribute the virtual-access 1
That number may change from time to time So you cant configure
Rotuer ospf 1
Redistribute connected subnets route-map CONN>OSPF

Route-map CONN>OSPF permit 10
 Match interface virtual-access 1
Route-map CONN>OSPF permit 20
 Match interface virtual-template 1

First line you cant because the number #1 can change from time to time.
Second line you cant because virtual-template is always down/down so it wont
show up in the routing table.

Try using ACL matching the subnet or a prefix-list

HTH

Santiago E

-----Mensaje original-----
De: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] En nombre de
Shaukat Khalil (shkhalil)
Enviado el: Jueves, 26 de Marzo de 2009 06:37 p.m.
Para: Raghav Bhargava; Cisco certification
Asunto: RE: Regarding Virtual Template

Raghav,

That will always be the case. The Virtual Template (VT) interface will
always be down/down. It is not a physical or even a logical interface
but simply the template which holds the parameters for Virtual-Access
interfaces to be cloned from. Thanks.

Shaukat

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
Raghav Bhargava
Sent: Thursday, March 26, 2009 3:33 PM
To: Cisco certification
Subject: Regarding Virtual Template

Hi Experts,

Just a silly question. When we create Virtual-Templates, it
automatically creates virtual-access for it.My query is, is it normal
to see Virtual-Access up and Virtual template down.
Does this output looks ok to everyone??

r1#sh ip int brief
Interface IP-Address OK? Method Status
Protocol
FastEthernet0/0 131.1.111.1 YES manual up
up
Serial0/0 unassigned YES unset up
up
Serial0/0.2 131.1.12.1 YES manual up
up
Serial0/0.3 unassigned YES manual up
up
Serial0/0.4 unassigned YES manual up
up
FastEthernet0/1 unassigned YES unset administratively
down
down
Serial0/1 131.1.100.1 YES manual down
down
Virtual-Access1 unassigned YES unset down
down
*Virtual-Access2 131.1.13.1 YES TFTP up
up shows up...*
Virtual-Access3 131.1.14.1 YES TFTP up
up*
Virtual-Template13 131.1.13.1 YES manual down
down <<<<<<<<<<<<<<<< shows down*
Virtual-Template14 131.1.14.1 YES manual down
down
Loopback0 150.1.1.1 YES manual up
up
Loopback1 1.1.0.1 YES manual up
up
Loopback2 1.1.1.1 YES manual up
up
Loopback3 1.1.2.1 YES manual up
up
Loopback4 1.1.3.1 YES manual up
up

If this out put looks ok , then can please someone explain ...

thanks for all the support

--
Warm Regards
Raghav
Blogs and organic groups at http://www.ccie.net